Search the Community
Showing results for tags 'sega model 3'.
Found 3 results
Hello Everyone! So after reading a bunch of help files and posts, I decide to make one that is hopefully super easy and understandable for noobs (barely understand CMD commands.) like myself when it comes to setting up the Sega Model 3 controls. This worked for me, so hopefully it also works for you. Here we go: After downloading the Sega model 3 emulator and unzipping it into your emulators folder, right click and make sure it runs as ADMINISTRATOR Go to your Start button, press it and type in the search bar "CMD", then right click on the result and "Run as Administrator" You should get a screen that is a DOS PROMPT Open the folder window where your emulator is located at and click in the bar to show the location of the folder. My folder is E:. Right Click and Copy Go to your CMD window and "right click and PASTE" You should now be in the drive and folder where your emulator is located at. If not, To access another drive, type that drive’s letter, followed by “:”. For instance, if you wanted to change the drive from “C:” to “D:”, you should type “d:” and then press Enter on your keyboard. Once you are in the drive your CMD prompt should be pointing to the folder that your emulator is at. type in this at the prompt: supermodel -config-inputs It will then give you a SECOND DOS window that is blank, DO NOT CLOSE THIS WINDOW, just move it to the side Click back on the original window to make sure FOCUS is on that one. Press Enter to activate mapping and you will see the word SETTING pop up. Now press the key you want to map to each control question. Follow through each one and you can always press ESC to cancel the selection and try again. When you are done. PRESS q Your done! Enjoy Sega Model 3!