[UPDATING ISSUES]

On 7/16/2019 at 8:04 PM, shadowfire36 said:

I recently updated to 9.10  and i had the exact same issue happen when i up the last few times, so i was wondering if anyone has had something similar

.

1st>I run launch box> auto update starts >I hit cancel update> and my launchbox no longer runs >everything is wiped and then i restore from backs ups. 

after

2>I update metadata and all of my boxes change to the japanese boxes after i click on any games .

 

anyone ? 

 

I updated today as well. and suddenly my launchbox whould not load at all.  i  have a older system, but well inside the specs.  i tried to install the previous version through the update folder. but the installation cancelled itself out.  so i went back more versions, and the last 2018 version installed properly and worked as a charm.  wierd . i am not sure if i dare to accept further updates from now on

[How to configure dpad on controller]

Just now, Lordmonkus said:

Rewire your joystick so the directions are correct.

i see. i was hoping there was an easier way , like in emulators.  but thanks anyway  

[How to configure dpad on controller]

[How to configure dpad on controller]

6 minutes ago, Lordmonkus said:

You haven't provided any details on the controller at all but LB has auto-detected and assigned all controllers I have used with it, Xbox360, Hori Fight Commander, Logitech F710 and even my flight stick and I can control LB/BB with everyone perfectly fine.

I havent provided any detalis because this is not a regular gamepad.   it is a chip board with manual wiring to every single buttons. i use this in an arcade cabinet i have built .  the arcade stick (dpad)  is preconfigured in lb to read only fixed assigment.   the problem is that i have inserted the stick a quarter to much clockwise.  so when i move the stick to right, it registers as "up". therefore i need to know if there is any way to manually overwrite the dpad on a controller in such a way that i can reassign  the right button to be read as "up", and so forward  , i have already done this in every emulators i use in LB/BB , but it does not seem possible in the LB/BB itself 

[How to configure dpad on controller]

no one who knows?

[How to configure dpad on controller]

Hi , i`m new her. 

If you could be so nice to guide me to how mapping the direcrional pads on my joystick pad (usb generic controller, manually wired) 

you see, i have no problem assigning the function buttons in launchbox/bigbox.  but the directional buttons is not possible to manually assign? . 

i have done this in the emulators, but in the front end program , the left is down and the right is up . any hints to where if possible i can change this?