Bigbox box art flipping?

[TrailerVert]

 

 

In game view the box front image keeps flipping vertical. I can’t seem to find the setting to stop it. Any ideas. Not every image flips but it does do it on all tested themes. 

[JoeViking245]

37 minutes ago, TrailerVert said:

In game view the box front image keeps flipping vertical. I can’t seem to find the setting to stop it. Any ideas. Not every image flips but it does do it on all tested themes. 

That looks like a 3D Box Model (not to be confused with a 3D Box Image).  It rotating indicates your controller joystick is "being pressed" up (or down).  I believe the right joystick it the default for rotating that image.  Give it a flick.

If you have a different kind of controller, look in the controller mappings to see what's mapped for rotating that and check it.

[TrailerVert]

Ok thanks. Currently only have a keyboard hooked up to it but will try a different keyboard and check controller mapping. 

[TrailerVert]

Getting closer. Here is what I found out. Not spinning when,  I have a Bluetooth controller hooked up and powered on. in BB controller settings, have Device set to Bluetooth XINPUT device. I am then able to move the 3d model around with the right analog stick like normal. 

Once the Bluetooth controller is turned off. The 3D model will start to spin again. In BB controller settings the Device setting will switch to Ipac4 instead of blank or Bluetooth XINPUT device. 

Ipac4 is set to keyboard mod. Have uninstalled Ipac4 from windows and reinstalled. 

I have a second setup with a Ipac2 and it does not ever list the Ipac2 as a controller. 

anyone else ever see this issue. 

Edited October 31 by TrailerVert

[JoeViking245]

On 10/31/2025 at 12:00 PM, TrailerVert said:

Ipac4 is set to keyboard mod. Have uninstalled Ipac4 from windows and reinstalled. 

I have a second setup with a Ipac2 and it does not ever list the Ipac2 as a controller. 

(have to ask...)  Are you sure your I-PAC 4 is set to Keyboard Mode ("Mode 1")?  And not Dinput or Xinput mode (Mode 2, 3, 4 or 5)?  It shouldn't show as a controller if it's Keyboard Mode (as I suspect is what the I-PAC 2 is in).

Even if its software is uninstalled and reinstalled, the physical I-PAC device retains its programming.  So you'd need to change its mode via the software or by pressing the mode button-combos.

[TrailerVert]

You are correct. Definitely something with the ipac or the way windows is seeing it. It does say it’s in keyboard mode, I believe. Here is what I see, if I can get a pic to upload. Let me know if this is what you are talking about. 
 

[JoeViking245]

Yeah, it says "Board is in Keyboard Mode".  But can't read what board is attached.  I can read "PAC" and assume that's a "4" after it (though doesn't really matter).  I only have an older I-PAC Mini that doesn't have any options other than Keyboard Mode.  So what I asked before is about the extent of my knowledge. 😊

Hopefully someone who has an I-PAC 4 running in keyboard mode can chime in with their findings.

[TrailerVert]

THANK YOU! 
I appreciate all your help, and thank you for all you do for the community. 
 

I will post back if I discover anything. 👍