new user, new install, Dolphin wont startup

[Racing4funn]

Got a few roms loaded and when running them Dolphin auto starts but just sets there.  Its just it's blank startup screen.  i tried to adjust the resolution within dolphin but it dosent start the rom.

[Lordmonkus]

Check your edit emulator window for your Dolphin setup in Launchbox.

[Racing4funn]

Thank you!  Copied the settings per your pictures and the rom took forever to load so I unzip the rom in the folder and now it flashes up..  Thanks to you!!!

[Lordmonkus]

Good to hear it worked, i'm guessing you were missing the command line parameters ?

[Racing4funn]

Maybe.. probably..  I believe so..

I input them and the "Extract Rom before Running" check box at the same time..  Then after a really slow load I unzip the roms permanently its storage directory.

 

Now my USB wire connected GameSir G3w (xbox clone) controller is only half recognized in Dolphin.   Configuring as a standard controller, it works with the A button and both Control Sticks and thats about it.  It wont configure the B, X, Y buttons, Start button, and the D-Pad.  Looking up the controller under windows 10 and using the test/setting and properties, it completely works (all buttons)

Any ideas?  Do I need to post this in another section?

[Lordmonkus]

You can check out a couple of videos on it, one is an older tutorial from Brad but still relevant and the other is from ETA Prime which covers some Launchbox installation that you may want to skip over.

 

 

[neil9000]

5 hours ago, Racing4funn said:

Maybe.. probably..  I believe so..

I input them and the "Extract Rom before Running" check box at the same time..  Then after a really slow load I unzip the roms permanently its storage directory.

 

Now my USB wire connected GameSir G3w (xbox clone) controller is only half recognized in Dolphin.   Configuring as a standard controller, it works with the A button and both Control Sticks and thats about it.  It wont configure the B, X, Y buttons, Start button, and the D-Pad.  Looking up the controller under windows 10 and using the test/setting and properties, it completely works (all buttons)

Any ideas?  Do I need to post this in another section?

I have a Gamesir G4S with the same problem, it's a controller/Emulator issue, nothing you can do unfortunately other than use another controller for Dolphin.