jeck11 Posted March 12, 2017 Share Posted March 12, 2017 Hello, I'm sure this is a stupid question but I've watched a few setup videos and been searching and can't find the answer. How do I configure save state and load state in Launchbox? I'm primarily using Retroarch but don't know if that matters. Link to comment Share on other sites More sharing options...
fromlostdays Posted March 12, 2017 Share Posted March 12, 2017 You don't configure it in launchbox. You configure it in RA, both the paths and the hotkeys. Sent from my SAMSUNG-SM-N910A using Tapatalk Link to comment Share on other sites More sharing options...
fromlostdays Posted March 12, 2017 Share Posted March 12, 2017 Well I should say you configure that in whatever emulator you are using. In RA options menu, I think it's directories to set the path, and note any directory thar says "content" will save to your rom path. This can be a good thing if you have your roms in individual folders. Sent from my SAMSUNG-SM-N910A using Tapatalk Link to comment Share on other sites More sharing options...
SentaiBrad Posted March 12, 2017 Share Posted March 12, 2017 By default the hotkey is F2 to save state, and F4 to load the save that. F3 changes the slot I believe, but I could be wrong. @fromlostdays is totally correct though, this is per emulator and LaunchBox doesn't effect it. If you want to save state from a controller, you do need to set that up in the options or if you want to change the default save locations. Link to comment Share on other sites More sharing options...
jeck11 Posted March 12, 2017 Author Share Posted March 12, 2017 Ok thank you very much. I'll have to look through the RA options a bit more then. Link to comment Share on other sites More sharing options...
jeck11 Posted March 13, 2017 Author Share Posted March 13, 2017 (edited) Just so that others can find it if this comes up in their search... These are defined in Retroarch under the Gear -> Input -> Input Hotkey Binds Then you'll want to scroll about 2/3 of the way down to "Enable hotkeys". This will set the first button you will press to get a hotkey to work (ie most people use "select"). Then you can set the various actions to the other button you want as part of the combo. For example, save state = right shoulder button will make the combo select + right shoulder. Edited March 13, 2017 by jeck11 Link to comment Share on other sites More sharing options...
Recommended Posts